![]() My 9207-8e, on the other hand, won't let me configure any RAID options. On my H200, it's in IR mode, and does let me configure RAID options. Usually the best thing is to boot into the OROM and see if it'll let you configure RAID options. The PERC H200 and 6Gbps SAS HBA cards comply with the T10 SAS 2.0 specification, providing upto 6 Gb/sec throughput, and improved hardware performance. However, not every card will make it obvious: The Dell PowerEdge RAID Controller (PERC) H200 and the 6Gbps SAS HBA cards are part of the third generation of the Dell Serial-Attached SCSI (SAS) RAID controllers. IR is Initiator Receiver - that's "RAID" mode). PERC H200 Modular (Only good for Dell Blade type Servers) Choose wisely in your eBay hunt as to which version the seller is advertising for sale, as you will find versions listed in error as each other. This particular guide has a section on IT vs IR firmware (IT is Initiator Target - that's "HBA" mode. How will I know if the card is or isn't already flashed? Currently it says it's a Dell H200 but the firmware and such on screen all say Logitech.Ĭan you access the H200's BIOS Configuration utility (often called OROM - or Options ROM)? Usually Ctrl + R, but it'll flash on the screen during the BIOS post process. So as I'm preparing to flash this card (thank you for such detailed instructions) I want to ask. ![]() I read that the 200 will allow the drives to be read and work independently of raid. Sorry to revive an old thread, but I've recently swapped an H200 for my H700. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |